Virtual Cockpit Install

[zainz]

Hi there guys I was wondering if someone can assist with Virtual Cockpit installation. I have ODIS online and I have put in a mk7 golfCockpit, everything works as it should but it will not start. Obiously due to Component Protection.

When I try adapting the cluster it doesn't recognise the key unless I put the original Analogue one back in. Anyone have any ideas where I can go from here?

Anyone know which VW share the same immo type as the crafter

 

[Tor]

My understanding is that the dash also contains the immobilizer, new dash = no start.

You can get a digidash from everest-vw which uses the original dash PCB to get around the issue, cost around £550 and requires a bit of DIY with a Dremel to get it to fit.

 

[IronDad75]

My understanding is that the dash also contains the immobilizer, new dash = no start.

You can get a digidash from everest-vw which uses the original dash PCB to get around the issue, cost around £550 and requires a bit of DIY with a Dremel to get it to fit.

I read that these are the same as the ones from AliExpress that I fitted for about £300. A few bugs with the software. Simple enough to fit though

 

[Tor]

I think they are the same, I had one but it just wasn't for me, mainly because the van is still under warranty and I didn't want to dremel the van to get it to fit.