Egr and cooler replacement.

Raul a/3

Raul a/3

Active member
Pro
I'm just about to start taking out the old egr and cooler. I have a brand new replacement and rear egr gasket. The front cooler pipe, I'm missing the gasket.
-Could I use a bit of exhaust paste on the old gasket?
-Also, the new egr, will it need adaptation after its all in?
Thank you all.
 
Right, I hit another problem. The new cooler comes without coolant breather take off, could I use it by blanking off the hose and bleed via vcds? All it does that helps bleed the egr cooler body.
 
Ok, egr and cooler it's in. I blanked the spare breather hose that suppose to connect to the cooler, but it's missing the hose connection. I started my second task, to remove the heater matrix and replace with a new one, before I fill the coolant and bleed the system. All the trim is off, glovebox off, but run out of daylight. Tomorrow, to be continued.
 
You must log in or register to reply here.
Back
Top